Archive Search Results
Showing
301 - 316
of 316
, query time: 0.01s
301. Mantrip
Format:
Image
Loading up for transportation to lower levels in the mine. The 16-10 incline goes down to the 18 level (at one time it went all the way to the 24 level). Transporting people was called a mantrip.
In the front seat are Terry Pierson, Ella and Pete Burnett. Victor Pierson is standing at left in the yellow helmet.
302. Cap Lamp Room
Format:
Image
From left, Bill Burnett, Hawkeye (Gordon) Flaherty, and Ella Burnett are standing in front of cap lamp units at 16 level in the Gilman mine. Alberta Limatta is at far right.
The shaft house had a 2 cage lift system, taking miners between levels. It could work with one cage going up and the other down, or with just one isolated cage moving. Cap lamps were put on before going into the mine and returned upon coming out.
Format:
Image
Dick Sayers (l) and John Skinner (r) at the pumping station on 20 level at Gilman.
"Water for the mine came directly from the Eagle River from the pump house, which was just across the ramp coming down the mill incline. About 50 tons of ore per hour went through the mill during each eight-hour shift." Eagle River Valley, p.38
Format:
Image
Emmet Flaherty preparing to pre-heat two blank pieces of hollow drill steel. In the background is an automatic oil-fired forge which will bring these blanks to an exact temperature for forging. From the hollow drill blanks, finished pieces of lugged steel are formed for use in rock drills.
307. Installing new dryer
308. Gilman
309. Gilman
311. Pearl and Harry Mize
Format:
Image
Pearl Dump Mize (born December 21, 1911 in Red Cliff), married Harry Mize in 1933. Harry was the son of Bill Mize (Bozeman, Red Cliff, Salida). Pearl worked as a secretary in Gilman from 1950 to 1969. Harry worked as a Maintenance Foreman in Gilman from 1950 to 1972. They have one son, Dick Mize, raised in Gilman, living in Anchorage, Alaska.
This picture was taken in August 1975 in front of their retirement home in Salida, Colorado.
312. Tailings pond
313. Drills and lathes
Format:
Image
Tearing down the existing tailings pipe and stands at the tailings pond below Gilman. Once enough sediment had been released through the bottom of the pipe, new stands were erected to lift the pipe to a higher elevation. Harv Collins is in the center of the photo wearing light colored coveralls.
Format:
Image
New section of pipe and stands for the tailings pond. Trusses with new sections of pipe are being built. Later a safety cable was added along a catwalk , which was used by employees to remove the plugs in the pipe and drain the tailings. Tailings were piped from Gilman as a slurry and, as the slurry dried, it became the same consistency as a fine sand.